Delete All Channels; Factory Preset; Software Update - Schweiger DSR 5010 Bedienungsanleitung

PC to Receiver (PC - STB)
You will need a suitable software to be able to transfer the channel information from a receiver to
your PC and vice versa. This software will be provided upon request.
Please visit SCHWAIGER website : www.schwaiger.de
Use a RS-232C cable (cross type) to connect the Receiver to your PC.
In your PC programme set your PC as "Sender (Set to Set)". "Sender" signifies the device that
is transmitting the channel information.
On the receiver go the Main Menu, select "Installation" and then select menu option "Data
Transfer".
Set your receiver as "Receiver (STB <- PC)"
Follow the instructions on the PC program to complete the rest of this process.

10.11 Delete all Channels

This function will delete all channel data from the receiver.All other individual settings will be kept.
Go to the Main Menu, select "Installation", select "Delete All Channels".
Enter password upon request
A warning message appears. Press "EXIT" to cancel or OK to confirm.
The "Welcome" screen appears. Make your language selection and press OK.
GB
Follow the instructions on the screen: either load the pre-programmed channel data or start your
individual channel search process.

10.12 Factory Preset

This function will delete all channel data and all individual settings from the receiver.
The pre-programmed channel data will be loaded again, and all settings will be reset to their
default values.
Go to the Main Menu and select "Factory Preset".
Enter password upon request.
A warning message appears. Press "EXIT" to cancel or OK to confirm.
The "Welcome" screen appears. Make your language selection and press OK.
Follow the instructions on the screen: either load pre-programmed channel data or start your
individual channel search process.

10.13 Software Update

If required, the latest development of the receiver operating software can be loaded to this unit by
software update. There are two kinds of software update procedures: Software update through
satellite (ASTRA 19
method of Software update through PC, using the RS-232 data interface on the rear side of this
unit.
Software update through Satellite
Go to the Main Menu and select "System Information".
Use this to check the software version or release date of the
current software before upgrading. System information
screen offers date, software version, and firmware.
The software version is updated by downloading the new
software via the satellite. Prerequisite for this is that a more
up-to-date version is available.
O
EAST). This method is also known as "OTA" ("Over The Air"). Also, there is a
22