Safety Notes - Schweiger DSR 5010 Bedienungsanleitung

3. Safety Notes

This set top box (STB) has been manufactured to satisfy the international safety standards.
Please read the following safety precautions carefully.
MAINS SUPPLY: 95 to 250V AC (no voltage selection)
OVERLOADING : Do not overload a wall outlet, extension cord or adapter as this may
result in fire or electric shock.
LIQUIDS :
objects filled with liquids, such as vases, shall be placed on the apparatus.
CLEANING : Disconnect the STB from the wall outlet before cleaning. Use a light
damp cloth (no solvents) to dust the STB.
VENTILATION : The slots on top of the STB must be left uncovered to allow proper
airflow to the unit. Do not expose the STB to direct sunlight or do not place it near a
heater. Do not stack electronic equipments on top of the STB.
GB
ATTACHMENTS : Do not use any accessories that are not recommended by the
manufacturer of this unit as these may cause hazard or damage the STB.
CONNECTION TO THE ANTENNA : Disconnect the STB from the mains before
connecting or disconnecting the cable from the antenna. Failure to do so can damage
the antenna.
CONNECTION TO THE TV : Disconnect the TV from the mains before connecting or
disconnecting the cable from the STB. Failure to do so can damage the TV.
GROUNDING : The antenna cable MUST BE EARTHED to the system earth of the
antenna. The grounding system must comply with national standards for
electrical safety.
LOCATION: The STB is designed for indoor use only. Do not expose it to lightening,
rain, or direct sunlight.
General
Do not remove the cover.
Do not allow the unit to be exposed to hot, cold or humid conditions.
Do not connect or modify cable when the STB is plugged in.
Use a soft cloth and a mild solution of dish washing liquid to clean the casing.
Never allow liquids, spray or other materials to come into contact with the inside of the
STB.
Service should be carried out only at a authorized service centre, contact your local
dealer for more information.
Please note that the unit will be isolated completely from the 230V mains supply only
after switching off the POWER switch on the front panel.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
The STB shall not be exposed to dripping or splashing and that no
4