Manual Search Function; Transponder Editor - Schweiger DSR 5010 Bedienungsanleitung

10.8 Manual Search Function

Use this channel search by entering the TP information manually to the receiver. This channel
search is often used to search for a particular channel or those channels that "Auto Search" has
missed, but it requires comparatively more expertise.
Select "Manual Search" and then press the OK button.
Select the satellite you want to track.
Set the LNB information and DiSEqC information for the
satellite. You can use the existing setting. To change the
setting, use the
Set the LNB polarization of the TP to "Horizontal" or "Vertical".
After the settings are completed, select "Next" and then press
the OK button.
Set the Down Frequency of the TP.
Set the Symbol Rate of the TP.
Select the type of channels to search: FTA, Scrambled, ALL or Network.
Press the OK button to start searching using the above settings.
Another search method is "Advanced Search". Use this channel search to search for a particular
channel or channels ones that you couldn't find using "Manual Search". Enter the PID of the
channel you want to search.
GB
Set the channel's Video PID.
Set the channel's Audio PID.
Set the channel's PCR PID.
Press the OK button at "Start Search"
The names of the channels will be listed.
Press the EXIT button to return to viewing mode and check that the reception of the selected
channel is good.

10.9 Transponder Editor

The "Transponder Editor" allows you to change, add, and
delete satellite information.
Go to the "Main Menu", select "Installation", select
"Transponder Editor", and then press the OK button.
Add a Satellite
Use the
Press the OK button. The screen will change to allow you to
enter the name of the satellite you are adding.
Use the
change the cursor position.
When you have finished entering the satellite name, press
OK.
Press the OK button to enter the added satellite's TP
information of the added satellite.
When the TP information input field appears in the right panel,
press the OK button.
Enter the TP information, such as Frequency, Polarization (H /
V), Symbol Rate, etc., and then press the OK button. (Use the
Numeric buttons to enter Frequency and Symbol Rate
information, and use the
information).
To cancel the entries you have made, press the BACK button or the EXIT button.
buttons.
buttons to move to the last field on the list.
buttons to enter letters. Use the
buttons to enter H / V
buttons to
20