Data Transfer - Schweiger DSR 5010 Bedienungsanleitung

Delete a Satellite
Use this to delete the selected satellite. However, you won't be able to delete any of the satellites,
which were set as factory defaults.
Use the CH UP and CH DOWN buttons to select the satellite you want to delete.
Press the button. A message appears, asking for your confirmation.
If you want to delete, press the OK button.
Otherwise, press the "Back" button or the EXIT button.
Modify Satellite TP Information
To modify the TP information, move to the satellite you want and then press the OK button.
The satellite TP information appears on the right side of the screen.
Select the TP information you want to modify and then press the OK button.
Modify the TP information, such as Frequency, Polarization, Symbol Rate, etc., and then press
the OK button. (Use the Numeric buttons to enter Frequency and Symbol Rate information, and
use the buttons to enter H / V information).
After the changes are made, press the OK button to update the TP information.
To cancel the TP information modification process, press the BACK button.
Add Satellite TP Information
Move to the bottom of the screen where the satellite TP information is displayed and then press
the OK button.
Enter the TP information you want to add, such as Frequency, Polarization (H / V), Symbol Rate,
etc. (Use the Numeric buttons to enter Frequency and Symbol Rate information, and use the
buttons to enter H / V information).
Press the OK button to register the TP information.
To cancel the TP information addition process, press the BACK button.
Remove Satellite TP Information
Move to the TP information you want to delete.
Press the LEFT button. A message asking for your confirmation asking for your confirmation
appears.
If you want to delete, press the OK button. Otherwise, press the BACK button or the EXIT
button.

10.10 Data Transfer

This is intended to transfer the channel information on one
receiver to another receiver of the same model / version.
You can also transfer channel information from your PC to
a receiver.
Receiver to Receiver (STB - STB)
Use a RS232C cable (cross type, "0-modem") to connect
both receivers.
Go the Main Menu, select "Installation" and then select menu
option "Data Transfer".
Select "Sender (Set to Set)" for the receiver that will send the
channel data.
Select "Receiver (Set to Set)" for the receiver that will
receive the channel data.
Press the OK button on both receivers to start the transfer.
"Sending" appears on the sending receiver and "Receiving" appears on the receiving receiver.
The transfer progress bar shows the progress of the channel data transmission. When the
transfer is completed, "Complete" appears.
You can check that the channel data on the Slave and Master receivers are the same.
Cable Pin Configuration
(1) o --------- o (4)
(2) o --------- o (3)
(3) o --------- o (2)
(4) o --------- o (1)
(5) o --------- o (5)
21
GB