Getting Started; Connecting The Satellite Receiver; First Steps - Schweiger DSR 5010 Bedienungsanleitung

5. Getting Started

This chapter explains some settings you will need to make before using the receiver for the first time.
For easier operation the most popular TV and radio channels of ASTRA and Eutelsat (HotBird)
satellite have been factory-preset. The sorting in the channel list has been made according to the
viewing habits of many German-speaking TV viewers.
You may change the pre-programmed channel list or its sorting at any time.

5.1 Connecting the Satellite Receiver

Mains Supply
This unit is designed for any common mains voltage (95 ~ 250 volts, no adjustment needed).
TV Set
Connect the TV SCART connector on this satellite receiver to the SCART connector of your TV set,
using a commonly available 21-pole SCART cable.
Antenna
Connect the coaxial cable from your satellite antenna system (LNB) to the IF INPUT connector of
the satellite receiver.
For details, please refer to section "Rear Panel Connections".

5.2 First Steps

Press the POWER button (1) on the front panel to switch on
the unit. With the
toggle between "Operation" and "Standby" mode. In the
operating mode the 8-charater (VFD) front panel display
shows the Ch. name and number of the actual TV or radio
program. In the "Standby" mode the actual clock time will
appear in the display, provided it has been set correctly or has
been synchronized by a transmitter signal before. When the
POWER button (1) is OFF the front panel display does not
show.
During initial setup the language selection menu appears on
your TV. Use the
or on the receiver to select the language of your choice and
then press the OK button. When selecting ENGLISH, a
WELCOME screen appears on your TV screen:
Your Digital Satellite Receiver is factory pre-programmed.
After you have adjusted several settings in the GENERAL
SETTINGS menu you have to press [EXIT] for loading the
pre-programmed channel data.
If you don't want to use this data press [MENU] and select
INSTALLATION to start your own searching.
Press OK to enter the "General Settings" menu.
In the "General Settings" menu you can perform individual settings that are related to the local time
zone (summertime included), your TV set, and desired language selections. For adjustments,
please use the and
- Press EXIT for loading the pre-programmed channel data. That may take some 30 seconds.
(Please wait.)
or
- Press MENU for selecting the "General Settings" menu. Then select " 3. Installation" and
perform item "1. Auto Search" or item "2. Manual Search", according to your needs.
button on the remote control you can
and buttons on the remote control
buttons and see the explanations at the bottom of the menu screens.
9
GB