Your Receiver And Its Functions; Remote Control Functions - Schweiger DSR 5010 Bedienungsanleitung

4. Your Receiver and its Functions

4.1 Remote Control Functions

* Batteries
Before using the remote control unit for the first time please insert the supplied batteries according
to the instructions below:
- Open the battery compartment on the back of the Remote Control Unit.
- Install two AAA size batteries. Make sure that the (+) and (-) terminals are aligned correctly.
- Close the cover.
* Replacement
- Always replace all batteries at the same time.
- Mixing old and new batteries or mixing different types will reduce overall performance and could
cause leakage or rupture.
Keys and its Functions
1. ON / STANDBY button
To switch the Receiver ON and OFF(standby mode).In the OFF position the unit is in the "standby"
mode and is not disconnected from the power supply. For full isolation from the mains please use
POWER button on the front panel (see more in paragraph 4.2).
2. MENU button
To enter the main menu.
3. Cursor UP / DOWN buttons
To move up/down in the menus and change channels.
1 ON / STANDBY button
2 MENU button
3 Cursor UP / DOWN buttons
4 Cursor LEFT/ RIGHT buttons
5 OK (Enter) button
6 Numeric buttons (0 ~ 9)
7 RADIO button
8 AUDIO button
9 TIMER button
10 VOL (-) / VOL (+) buttons
11 FREEZE button
12 BACK button
13 free (F1) button
14 free (F2) button
15 TELETEXT button
16 EXIT button
17 EPG (Electronic Program Guide)
18 PAGE UP / DOWN button
19 LAST button
20 PROGRAM INFORMATION button
21 SUBTITLE button
22 MUTE button
5
GB