Advanced Operation; Rf Modulator; Lnb Settings; Diseqc Setting (General Setting) - Schweiger DSR 5010 Bedienungsanleitung

10. Advanced Operation

In this section some settings and operations are described that require certain expertise and basic
knowledge about satellite reception and digital TV for being carried out without fail. For most TV
viewers there should be no need to use, modify or adjust the items as described below.
In case of doubt please ask your dealer for support.

10.1 RF Modulator

In some rare cases there may be a necessity to connect this digital receiver without having
available SCART connectors or RCA audio / video input jacks on the TV set to be connected. In
such a case you can make use of the built-in RF modulator. It is designed to convert the video
output signal of this receiver into a normal analogue TV channel, using a free channel in the UHF
band that can be received with the connected TV set. Please note that, if proceeding like this, the
picture quality and audio quality does not meet digital standards.
Connect the TV out jack of this receiver with the ANTENNA input of your TV, using a standard
IEC coaxial antenna cable.
Go to sub menu "RF Modulator" in the "General settings" menu.
Select the desired UHF output channel (CH 21 ~ 69) according to local necessities, using the
buttons.
Press OK several times to select the desired TV standard (PAL B/G, PAL I, PAL D/K, or NTSC
M). The mostly used standard in Central Europe is PAL B/G.
Set up or tune your TV set to the selected UHF output channel.
Operate this receiver as usual.

10.2 LNB Settings

This receiver has been factory-preset to the requirements of the most commonly used LNB types.
You can check or modify the actual settings in the menu "Installation", sub menu "Auto Search" or
"Manual Search". In case you wish to edit the parameters using the "Auto Search" sub menu, you
need to press the GREEN button first. These are the preset items:
LNB Local Freq.
DiSEqC
22 kHz
0 / 12 V Control
These settings may need modifications if you use a specific LNB or a satellite antenna system that has
been installed with DiSEqC equipment (such as selector switches and / or motor antenna systems).
Please follow the instructions that come with this equipment or ask your dealer.
10.3 DiSEqC Setting (General Settings)
There is a DiSEqC option in the Main Menu. Please be sure to have selected the "DiSEqC 1.0" option as
long as you don't employ equipment according to "DiSEqC 1.2" or "USALS" standards. Changes can be
made using the buttons.

10.4 DiSEqC 1.0

In principle, there are two kinds of external DiSEqC switches on the market. One is for connection of two
LNBs, the other one is for connection of up to four LNBs. In the "Auto Search" sub menu you can select
the DiSEqC LNB input 1 / 2 / 3 or 4 for each LNB connected to the corresponding switch port of the
DiSEqC switch.
For details please follow the instructions that come with you DiSEqC equipment.
Universal
OFF
AUTO
0 V
17
GB