Front Panel Controls; Rear Panel Connections - Schweiger DSR 5010 Bedienungsanleitung

4.2 Front Panel Controls

The basic control functions of this unit (Menu, Exit,TV/RADIO, OK, cursor functions) can be carried
out by remote control and by front panel operations as well.
The mechanical POWER switch (1) is fully disconnecting the unit from the 230 Volts power supply.
When this button is set to the ON position there will be minimum power consumption also when the
unit is in "standby" mode. This is required for maintaining remote control and clock time functions.
When the unit will not be in use for a longer period of time we recommend to set the front panel
POWER button to the OFF position.
Note: When switching on again the POWER button (1) the clock time will not be available from the
beginning. After setting the unit to operating mode using the red ON / STANDBY button on the
remote control and receiving a TV or radio program the actual clock time will be taken over
automatically from the transmitter signal. Normally, time synchronization will take only a few
seconds.
Infrared (IR) signals are being received through the front panel IR sensor. The 8 -Charater VFD
(Alpha numeric) display is indicating the actual TV / Radio channel name and number of the
according channel list.

4.3 Rear Panel Connections

1. Mains Connection (95 ~ 250V)
This unit can be operated at all common AC power systems without voltage pre-selection.
2. RS-232 Data Interface
Computer interface for service stations and advanced users only. To be used for software update
and channel list data transfer from another receiver (master / slave).
1. 8 Charater VFD Display (Alpha numeric)
2. MENU Button
3. TV/RADIO Button
4. POWER Button (mains)
5. IR Sensor
6. EXIT Button
7. Cursor (CH Up / Down, Left / Right) Buttons
8. OK Button Buttons
1. Mains Connection (95 ~ 250V)
2. RS-232 Data Interface
3. Analog Video Output
4. Digital Audio Output (Coaxial)
5. Analog Audio Output (Stereo)
6. SCART Connector (TV)
7. SCART Connector (VCR)
8. VHF / UHF Antenna Input
9. UHF Modulator Output
10. LNB Input
11. LNB Loop-Through Output
7
GB