Replacing The Blade; Disposal And Recycling - EINHELL GE-CM 36 Li Originalbetriebsanleitung

Anleitung_GE_CM_36_Li_SPK7__ 19.12.12 13:15 Seite 26
GB
blade and make sure that it is tightly fastened. If
the blade is completely worn out, it must be
immediately replaced or ground sharp again. An
excessively vibrating mower means that the blade
is not properly balanced or has become deformed
from striking an object. In this case, the blade
must be repaired or replaced.
There are no parts inside the equipment which
n
require additional maintenance.

8.4 Replacing the blade

For safety reasons, we recommend having the blade
replaced by an authorized professional. Important.
Wear work gloves! Only replace the blade with a
genuine Einhell replacement blade, as this will ensure
top performance and safety under all conditions.
Carry out the following steps to change the blade:
Undo the fastening screw (see Fig. 16).
n
Remove the blade and replace with a new one.
n
When fitting the blade, make sure it is installed in
n
the right direction. The blade's air vanes must jut
into the motor compartment (see Fig. 16). The
dome mounts must be aligned with the punch
holes in the blade (see Fig. 17).
Then retighten the fastening screw. The tightening
n
torque should be approx. 25 Nm.
At the end of the season, perform a general
inspection of the lawn mower and remove any grass
and dirt which may have accumulated. At the start of
each season, ensure that you check the condition of
the blade. If repairs are necessary, please contact our
customer service center. Use only genuine spare
parts.
8.5 Ordering replacement parts:
Please provide the following information on all orders
for spare parts:
Model/type of the equipment
n
Article number of the equipment
n
ID number of the equipment
n
Spare part number of the required spare part
n
For our latest prices and information please go to
www.isc-gmbh.info
Spare blade art. no.: 34.054.850
9. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
26

10. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.