Setting The Length Of Taper Bar; Setting The Number Of Stitches Of Taper Bar; Setting The Offset Of Taper Bar; Setting The Sewing Speed - JUKI KI120X-1 Betriebsanleitung

(8) Setting the length of taper bar

1

(9) Setting the number of stitches of taper bar

1

(10) Setting the offset of taper bar

1

(11) Setting the sewing speed


2
Length
2
2
Offset amount
1 2
Set the length of taper bar.
1) Set the length of taper bar wth [RIGHT
1 or [RIGHT ] key 2 .
2) In case of wthout taper bar, set the value to 0
mm. In case of wth taper bar, the length can
be set 3 to 15 mm n the ncrements of 1 mm.
When the length of taper bar is changed,
the number of stitches of taper bar will
automatically change.
Set the number of stitches of taper bar.
Set the number of sttches of taper bar wth [RIGHT
] key 1 or [RIGHT
The number of stitches can be set to such
an extent of 0 to 20 stitches. The number
of stitches that can be set is limited by
the set value of the length of taper bar.
Example) When the length of taper bar is equal
to 6 mm, the number of stitches is 2
to 12 stitches.
Set the offset amount from the center of
taper bar.
Set the offset amount wth [RIGHT
[RIGHT ] key 2 .
The offset amount can be set 0.5 mm to 2.0 mm n
the ncrements of 0.1 mm.
Set the sewing speed of the whole sewing.
Set the sewng speed wth [RIGHT
[RIGHT ] key 2 .
The sewng speed can be set 400 st/mn to 2,200
st/mn n the ncrements of 100 st/mn.
] key
] key 2 .
] key 1 or
] key 1 or