Dimplex EMB20-EU Montage- Und Bedienungsanleitung Seite 7

Operation
Press to turn the unit on and off or put it in Standby mode. When the unit is turned
Power
back on, it will retain the previously used settings (except timer).
Press the Heat button to cycle through the functions: low heat, high heat, cool airflow,
off.
The display will show "Lo" (low heat), "Hi" (high heat), or "Cb" (cool airflow). After two
Heat control
seconds, it will show the room temperature. The heat icon on the touch panel will be
illuminated when one of the heat settings is active.
Use the Temperature icon to adjust the thermostat.
Press multiple times to cycle through the temperature settings: 62°F to 92°F (17°C to
32°C).
Temperature Press once to display the set temperature. It will flash for 3 seconds, then show the
room temperature.
Remote Control: Use the temperature + or - buttons to adjust the temperature.
On the touch panel, press and hold the Heat and Temperature buttons simultaneously
( + ) for 5 seconds to disable the heater.
Disable Heat To enable the heater, press and hold the same buttons again for 5 seconds.
When the heater is disabled, "--" will display when the Temperature button is pressed.
All other controls will function normally.
The display can show the temperature in °C or °F.
°C or °F.
To switch between units, press and hold the Temperature and Flame buttons
simultaneously ( + ) on the touch panel.
Press the button to cycle through flame speeds: minimum (F1), medium (F2), and
Flame Speed
maximum (F3).
Press the button multiple times to turn the media on/off and change the media colours.
The display will show the theme (t0, t1, t2, etc.).
Theme t0: Midnight mode
Theme t1: Media white
Colour
Theme t2: Media red/orange
Themes
Theme t3: Media blue
Theme t4: Media purple
Theme t5: Media green
Theme t6: Prism mode (colour cycle)
Press the button to turn the flame on or off.
Flame
Note: If the flame effect is off while the heat is on, the heat indicator light will stay on to
show that the heat function is active.
Press the button multiple times to set the sleep timer in 0.5-hour increments, from 0.5
hours to 8 hours.
Timer
Press again to display the remaining time on the timer.
Note: When the timer is active, the timer indicator light will be illuminated.
Brightness Press the button to change the flame brightness: high, medium, or low.
7