Battery Replacement; General Maintenance - Dimplex Emb20-Eu Montage- Und Bedienungsanleitung

Maintenance

Battery Replacement

1. Remove the screw on the battery cover using a Philips screwdriver.
2. Depress the tab and pull out to release the battery compartment on the bottom of the remote
control.
3. Correctly install one 3 Volt (CR2032 [longer life] or CR2025) battery in the battery compartment.
4. Insert the battery compartment and secure it with the screw.
Battery must be recycled or disposed of properly. Check with your Local Authority or
Retailer for recycling advice in your area.
Resetting the Temperature Cutout Switch
Should the heater overheat, an automatic cutout will turn the heater off. It will not come back on without being reset.
To reset the cutout switch, unplug the unit and wait 5 minutes before plugging it back in.

General Maintenance

Inspect the electric firebox regularly, depending upon conditions, and at a minimum yearly intervals. Remove dust
and clean with a damp cloth as required.
CAUTION: Except for installation and cleaning described in this manual, an authorized service representative
should perform any other servicing.
WARNING: Disconnect power by unplugging the power and allow the heater to cool before attempting any
maintenance or cleaning to reduce the risk of fire, electric shock, or injury.
If you are having issues with your firebox, please contact the place of purchase.
10 www.dimplexfires.com