Working Procedures; Use And Handling; Preparing The Kerf - Parkside Paks 20-Li E5 Bedienungsanleitung

Clean the drip oiler
o
guarantee a trouble-free, automatic
oiling of the saw chain
operation. Use a brush or a cloth to
help remove residues from the oil
passage.
˜ Working procedures
WARNING! Risk of injury!
m
Sawing and felling work as well
u
as all associated tasks may only
be carried out by properly trained
operators.
NOTE
Note your country's laws regarding
u
felling work and contact the
appropriate authority for more
information.
Only the required personnel should
be in the working area.
Make sure that no one can be injured
o
by falling branches and trees.
Keep the area around the trunk free
o
and tidy to ensure secure footing for
the operators.
Keep all escape routes free and tidy
o
to ensure that the working area can
be evacuated quickly.
Do not carry out any felling work in
o
strong wind, poor weather or bad
visibility.
eep a distance of at least 2
o
lengths from next working area.
˜ Use and handling
Never start the product before the
o
guide bar , saw chain
[ 8 ]
sprocket cover
correctly.
Do not cut any wood that is lying
o
on the ground and do not attempt
to saw roots that are protruding
from the soil. Never allow the saw
54 GB/IE
in order to
[ ]
during
9 ] [
tree
1
2
and
9 ] [
have been tted
[ ]
chain to come into contact with
[ 9 ]
the soil, as this could blunt the saw
chain.
If the product accidentally comes
o
into contact with a solid object,
turn o the motor immediately and
inspect the product for damage.
Service the product carefully. Check
o
for misalignment or binding of
moving parts, breakage of parts and
any other damage that may impair
the product's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained tools.
Keep cutting tools sharp and clean.
o
Properly maintained cutting tools
with sharp cutting edges are less
likely to bind and are easier to
control.
Have the product maintained by
o
uali ed specialists.
Use only the replacement parts
o
recommended by the manufacturer.
˜ Preparing the kerf
(Fig. G)
WARNING! Risk of accidents!
m
Do not saw the hinge C at the
u
same time as the felling cut B
otherwise the tree could fall in an
unexpected direction!
Be prepared that the tree can ‚slip'
u
out of control onto the cut during
felling.
Be prepared that the tree can
u
"jump" in an unexpected direction
when it hits the ground.
NOTICE! Risk of product
m
damage!
Do not let the wedge come into
u
contact with the saw chain .
9 ] [