Herunterladen Inhalt Inhalt Diese Seite drucken

Tightening And Checking The Saw Chain; Use; Switching On And Off; Optimal Working Procedures - Parkside PKSA 20-Li A1 Originalbetriebsanleitung

Akku-kettensäge
Vorschau ausblenden Andere Handbücher für PKSA 20-Li A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Always clean the area around the chain oil tank
cap
before filling to prevent dirt getting into
the chain oil tank.
Use a dry, lint-free cloth to do this.
Turn the chain oil tank cap
and remove it.
The chain oil tank cap
chain oil tank with an loss-prevention device
and cannot fall onto the floor.
Add the supplied organic chain oil
chain oil tank.
Do not spill any chain oil while filling the chain
oil tank and do not fill the tank to overflowing.
Wipe up any spilt chain oil immediately.
Turn the chain oil tank cap
close it.

Tightening and checking the saw chain

WARNING!
Wear protective gloves! There is a risk of
injury from the sharp cutting teeth!
Check the chain tension before every use.
Undo the fixing screw
Turn the chain tensioning ring
direction to increase the tension.
The saw chain
must lie against the underside
of the blade.
Check whether the saw chain
brake off, pull the front hand guard
can be drawn by hand over the guide rail
Now tighten the fixing screw
NOTE
A new saw chain
tightened more often.
GB │ IE
40 
anticlockwise
is connected to the
to the
clockwise to
.
in a clockwise
(with the chain
to the rear)
.
completely.
stretches and must be

Use

Before starting the tool, always check that:
The protective equipment and cutting equipment
is complete and in perfect working order.
All screw connections are firmly tightened.
All moving parts can move smoothly and freely.
Switching on and off
Switching on:
Press the safety lock-out
and then press the ON/OFF switch
After starting, the safety lock-out
released again.
Switching off:
Release the ON/OFF switch

Optimal working procedures

Get to know the chainsaw before you start to use it.
Checking and adjusting the chain
lubrication
ATTENTION!
Never work without chain lubrication!
If the saw chain runs dry, the cutting equip-
ment may become irreparably damaged in a
short time.
Always check the chain lubrication before
starting work.
NOTE
Use only saw chain oil, preferably biode-
gradable. Do not use waste oil, motor oil, etc.
While working, check whether the chain
lubrication is working correctly.
With the chainsaw running, hold it over a sawn
off tree stump or a suitable ground sheet.
If the lubrication is adequate, a light film of oil
forms on the tree stump or the ground sheet
(see fold-out page, fig. D).
and keep it pressed
.
can be
.
PKSA 20-Li A1

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis