Checking The Chain Lubrication; Working Procedures; Use And Handling - Parkside Paks 20-Li E5 Bedienungsanleitung Und Originalbetriebsanleitung

Hand
Right hand
Left hand
Thumb and finger must close
securel over the handles
5. Switch on the product.
6. Wait until the product reaches the
highest speed.
7. Activate the chain brake (with
running motor): Push the front
guard away from the front
[ 1 ]
handle .
[ 2 ]
The saw chain
9 ] [
abruptly.
8. Once the chain brake is working
properly:
1) Release the on/off switch
2) Release the chain brake.
˜ Checking the chain
lubrication
1. Check the oil level and the
chain lubrication system before
commencement of work.
2. Switch on the product.
3. Hold the product above a bright
background.
The product must not touch the
–
ground.
If an oil trace can be seen, the
–
product is working trouble-free.
NOTE
If no oil trace can be seen:
u
Clean the drip oiler
–
Return the product to our
–
customer service for repair.
Clean the drip oiler
o
guarantee a trouble-free, automatic
oiling of the saw chain
operation. Use a brush or a cloth to
help remove residues from the oil
passage.
Handle
Rear handle
[ 6 ]
Front handle
[ 2 ]
/ .
[ 2 ] 6 ] [
should stop
.
5 ] [
or
[ ]
in order to
[ ]
during
9 ] [
˜ Working procedures
WARNING! Risk of injury!
m
Sawing and felling work as well
u
as all associated tasks may only
be carried out by properly trained
operators.
NOTE
Note your country's laws regarding
u
felling work and contact the
appropriate authority for more
information.
Make sure that no one can be injured
by falling branches and trees.
Only the required personnel should
be in the working area.
Keep the area around the trunk free
and tidy to ensure secure footing for
the operators.
Keep all escape routes free and tidy
to ensure that the working area can
be evacuated quickly.
Do not carry out any felling work in
strong wind, poor weather or bad
visibility.
Keep a distance of at least 2
lengths from next working area.
˜ Use and handling
Never start the product before the
guide bar , saw chain
[ 8 ]
sprocket cover
correctly.
Do not cut any wood that is lying
on the ground and do not attempt
to saw roots that are protruding
from the soil. Never allow the saw
chain to come into contact with
9 ] [
the soil, as this could blunt the saw
chain.
If the product accidentally comes
into contact with a solid object,
turn off the motor immediatel and
inspect the product for damage.
⁄ tree
1
2
and
9 ] [
have been fitted
[ ]
GB/MT 55