Pairing The Outdoor Sensor With The Weather Station; Setting Up Or Mounting The Weather Station - Renkforce Rf-6701490 Bedienungsanleitung

10.2 Pairing the outdoor sensor with the weather station

1. Slide the battery compartment lid (15) downwards to open the battery compart-
ment of the outdoor sensor.
2. Insert the batteries according to the correct polarity (+ and –) into the battery
compartment.
3. Press the +/CH button (8) one or multiple times to set the sensor channel on
the weather station:
Press the
+/CH button
1x
2x
3x
4x
Connection mode will remain enabled for 3 minutes after the base station is
switched on. This is indicated by a flashing antenna symbol.
5. Slide the radio channel switch (14) to match the channel of the weather station.
6. Attach the battery compartment lid (15) to close the battery compartment.
7. The outdoor sensor connects to the weather station.
Press and hold the +/CH button (8) for about 3 seconds to delete all data from
the outdoor sensors and restart the signal search.

10.3 Setting up or mounting the weather station

Hang the weather station on a hook, nail or screw on the wall using the opening
for wall-mounting (3) on its rear side.
The weather station can also be set up on a horizontal, stable and sufficiently
large surface using the fold-out table stand (5).
Sensor channel
Channel 1
Channel 2
Channel 3
Activate the automatic channel switch-
ing function
Display shows
39