Working With Your Dtu-1931; Setting Up Your Work Area - Wacom DTU-1931 Benutzerhandbuch

WORKING WITH YOUR DTU-1931

As you work with the DTU-1931 pen display you can rest your hand lightly on the display screen,
just as if it were a drawing board or sheet of paper.
Because the DTU-1931 surface will be a little higher than your desk, consider adjusting the height of
your desk or chair to assure comfortable use of the device.

SETTING UP YOUR WORK AREA

To minimize fatigue, organize your work area so you can work comfortably. Position your
DTU-1931, the pen, and your keyboard for easy access without unnecessary reaching. The pen
display and any other displays should be positioned so you can view them comfortably with a
minimum of eyestrain.
•
Take short breaks between tasks to stretch and relax your muscles.
•
Use a gentle grip when working with the pen.
•
Alternate tasks throughout the day.
•
Maintain a good posture at all times. Minimize awkward postures and repetitive movements
that cause discomfort.
•
Change your position if you feel any discomfort due to your work position.
Note: Wacom makes no representation, promise or guarantee that Wacom products will cure or prevent, in
whole or in part, mouse-induced repetitive stress symptoms, injuries or conditions. Individual results may
vary. Always obtain competent medical advice to determine the most appropriate treatment for your
specific situation.
Tips:
Be careful that you do not pull the cables out of their connections by accidentally moving the DTU-1931
too far from the computer.
The pen tether can be used to ensure your pen stays with your pen display tablet. Simply loop one end of
the tether through the tether hole located on the pen (if so equipped), and the other end of the tether
through the tether connection point located on the left or right side of the tablet.
The DTU-1931 can also be mounted to articulated arms or other third-party stands meeting the VESA 100
specification for display stands. For details, see Using an alternate mount or stand on page 40.
Working with your DTU-1931
Page 18