Working With Your Dtf-720; Setting Up Your Work Area - Wacom DTF-720 Installationshandbuch Und Benutzerhandbuch

WORKING WITH YOUR DTF-720

As you work with the DTF-720 interactive pen display you can rest your hand lightly on the display
screen, just as if it were a drawing board or sheet of paper.
Because the DTF-720 surface will be a little higher than your desk, consider adjusting the height of your
desk or chair to assure comfortable use of the device.

SETTING UP YOUR WORK AREA

To minimize fatigue, organize your work area so you can work comfortably. Position the DTF-720, the
pen, and your keyboard so they are easily accessible without unnecessary reaching. The pen display
and any other displays should be positioned so you can view them comfortably with a minimum of
eyestrain.
Here are some other points to keep in mind:
•
Take short breaks between tasks to stretch and relax your muscles.
•
Use a gentle grip when working with the pen.
•
Alternate tasks throughout the day.
•
Maintain a good posture at all times. Minimize awkward postures and repetitive movements that
cause discomfort. Change your position if you feel any discomfort due to your work position.
•
Alternate between different modes of use.
Note: Wacom makes no representation, promise or guarantee that Wacom products will cure or prevent, in
whole or in part, mouse-induced repetitive stress symptoms, injuries or conditions. Individual results may vary.
Always obtain competent medical advice to determine the most appropriate treatment for your specific
situation.
Tips:
• Be careful that you do not pull the cables out of their connections by accidentally moving the DTF-720 too
far from the computer.
• The pen tether can be used to ensure your pen stays with your pen display tablet. Simply loop one end of
the tether through the tether hole located on the pen, and the other end of the tether through the tether
connection point located on the left or right side of the tablet.
• The DTF-720 can also be mounted to articulated arms or other third-party stands meeting the VESA 75
specification for display stands. For details, see Using an alternate mount or stand on page 46.
Working with your DTF-720
Page 16