Using An Alternate Mount Or Stand - Wacom DTU-1931 Benutzerhandbuch

USING AN ALTERNATE MOUNT OR STAND

If you will be using the DTU-1931 in an installation that requires the use of an alternate mounting
platform, you can remove the adjustable stand from the unit and mount the pen display onto any
mount arm or stand conforming to the VESA 100 mm standard.
Mounting screws that are 4 mm wide with a 0.7 mm pitch (M4 Regular), with a screw clearance
depth of 15 mm are required. Exceeding the clearance depth of 15 mm will damage the pen display
internal components.
To remove the adjustable stand and
attach the pen display to a different
mounting platform:
1. Turn off your computer and power off
the DTU-1931. Then disconnect all
cables from between the unit and
your computer.
2. Protect the display screen surface by
spreading a soft cloth onto a flat
table and placing the DTU-1931 face
down on the cloth.
3. Remove the four screws and lift the
adjustable stand assembly away
from the body of the unit.
4. Using the appropriate screws for
your mounting platform, firmly attach
the DTU-1931 to the alternate
mounting platform.
5. Refer to the Installation instructions,
beginning on page 11, and reattach
the cabling.
C
AUTION
When attaching the DTU-1931 onto an alternate
mounting platform, be sure to follow all instructions
in the documentation supplied by the platform
manufacturer. If improperly installed, the unit could
fall, resulting in damage to the unit or physical injury.
Appendix
Page 40