Software Installation - Wacom DTU-1931 Benutzerhandbuch

SOFTWARE INSTALLATION

IMPORTANT: You MUST install the Wacom pen tablet driver software for correct pen-on-
screen functionality.
To install the tablet software:
•
Save your work and close all open applications. Temporarily disable any virus protection
programs.
•
Insert the Installation CD into your computer's CD-ROM drive. If the software installer menu
does not automatically display, double-click on the Install icon located on the CD.
•
Click on the I
NSTALL
•
Reactivate your virus protection program.
•
After completing the software installation, make sure you can use your pen on the DTU-1931
display to move the screen cursor.
When you place the pen tip on the display screen, the screen cursor should immediately jump
to a corresponding position approximately beneath the pen tip. Lift the pen tip and place it on
the display screen surface in a different location – the screen cursor should again jump to the
new position. This is known as absolute positioning, and enables you to position the screen
cursor without having to drag your pen across the display screen surface.
•
Be sure to check the Read Me file for updated information. If you have trouble installing the
DTU-1931, see the Troubleshooting section beginning on page 28.
Notes:
Driver installation automatically activates the new pen input functions available within Microsoft Windows
Vista and Office 2007 (except for Windows Vista Home Basic). Visit the Wacom web site at
www.wacom.com/vista for additional information on using your Wacom pen in Windows Vista.
User-specific preferences are supported. After logging in, each user can customize their personal settings
in the Wacom Tablet control panel. Switching to another user will automatically load the settings for that
user.
To uninstall the tablet driver, see Uninstalling the DTU-1931 on page 43.
If the pen display tablet does not respond properly or you lose cursor control, the tablet preferences may
be corrupted. You can delete the current preference settings and return the tablet to its factory default
condition. On a Windows system, run the T
on the Windows
START
P F U
REFERENCE ILE TILITY
Next, adjust the pen display tablet calibration to precisely align the screen cursor to the pen tip.
See Calibrating the DTU-1931 on page 23.
T link and follow the prompts to install the driver software.
ABLET
ABLET
icon and selecting A P
LL
.
P F U
REFERENCE ILE TILITY
. Then select W
ROGRAMS
. Access the utility by clicking
T and T
ACOM ABLET ABLET
Installation
Page 17