Using The Charger - Denver Villette E100 Rm Benutzerhandbuch

From the initial position 12 o'clock (where the battery and carrier are unlocked), insert the key into
the key slot, press and turn it clockwise to position 6 o'clock (Then the battery is locked with the
carrier). On the contrary, you can unlock it.
Battery charge
If an AC outlet is available within reach of your bike, you can charge your bike directly with the battery
still attached to the bike. The charging port is covered by a plastic cap, with a yellow arrow for notice
(Fig 4.3). Please open it, then you charge the battery directly.
Removing the battery is useful for charging in a location where the bicycle may not fit or when no
reachable AC power supply exists at the place where the bike is parked
Before removing the battery from the bike, you need to unlock as following steps
* make sure the switch is off.
* Press the key and turn it anti clockwise from 6 o'clock to 12 o'clock position.
* Remember to take off and care about the key after you withdraw the battery from the carrier!!!

Using the charger

Before charging the battery, please read the user manual and the charger manual, if supplied with your
bicycle. Please also note the following regarding the battery charger:
•
Follow the instructions on the battery charger label.
•
Do not use this charger near explosive gases or corrosive substances.
•
Do not shake the charger, knock it, and avoid dropping it.
•
Always protect the charger from rain and moisture for indoor use.
•
The temperature tolerance of this charger is between 0 and +40 °C.
•
You should not disassemble the charger, should you encounter any problems, give the device
to a qualified repairer.
50