Status Indicator Light And Sounds - Ecovacs Robotics Winbot X Bedienungsanleitung

5. Status Indicator
WINBOT emits beeps when encountering
solutions.
Indicator
WINBOT
Indicator
WINBOT
Safety Pod Status
Indicator Light
Battery Indicator
Safety Pod
Light
24
EN
Light and Sounds
problems. When you hear the beeps, please check the Status Indicator Light list below to find the
Status
Flashing BLUE
Status
Continuous BLUE
Light
Flashing RED
Continuous RED
Flashing GREEN
Continuous GREEN
Flashing RED
Continuous RED
Flashing RED
Continuous GREEN
Description
1. WINBOT is charging.
2. WINBOT has been paired with the Safety Pod already and is ready to
be placed on the glass.
I. WINBOT has successfully adhered
clean.
2. The Safety Pod is in preparation.
The robot's battery is low. Charge WINBOT as described
Please refer to Section 6. Troubleshooting for details.
The Safety Pod is not prepared to be pressed onto the glass:
I. The Safety Pod Jack is not inserted into WINBOT.
2.The Safety Pod is not paired with WINBOT.
3. The Safety Pod is not attached
4.The Safety Pod is pairing with WINBOT.
The Safety Pod is working normally. WINBOT
The Safety Pod's battery is low. Replace the battery as described in
Section 4.4.
Please refer to Section 6. Troubleshooting, for details.
The Safety Pod's battery is low. Please replace the battery as described
in Section 4.4.
The Safety Pod's battery is sufficient.
itself to the glass and is ready to
in Section 3.2.
to the glass safely and firmly.
can start working.