ECOVACS ROBOTICS WINBOT X Bedienungsanleitung Seite 28

6. Troubleshooting
No. Malfunction
WINBOT moves in an irregular
6
pattern during cleaning.
WINBOT is stuck, and cannot
move, be controlled by the
7
Remote Control, or be reset by
pressing RESET Button.
WINBOT does not charge after
the Power Adapter
8
correctly plugged in.
28
EN
Possible
There is too much
window.
Insufficient suction or Edge Detection Sensor
signal abnormity.
has been
WINBOT's Power
Causes
A. Replace the Cleaning Pad and restart the cleaning
cycle.
B. Clean the Driving Treads as described in Section 4.3.
C. Spray additional
dirt and debris on the pad.
D. Use the Remote Control to manually control the
cleaning
*WINBOT is intended to be used for maintenance cleaning
on common
replace heavy-duty cleaners or for first time cleaning.
Press the RESET
then press and hold it until the WINBOT
Light glows a continuous
Indicator Light glows a continuous GREEN to switch
WINBOT
In Manual Override
on the
Control Buttons to move WINBOT
from edges and where you can safely reach it. Remove
WINBOT from the window and power OFF. Power ON
again to restart.
*When using the Manual Override Mode, do not leave
WINBOT
If the problem persists, please contact Customer Service.
Move the robot's bottom Power Switch to the ON position
and make sure the WINBOT Status Indicator Light flashes
Switch is not set to ON.
BLUE.
Solutions
Cleaning Solution on the Cleaning
by pressing Direction Buttons.
windows. The product is NOT designed
Button on the Remote
BLUE and the Safety Pod Status
to Manual Override Mode.
Mode, the Direction Control Buttons
Remote Control are activated. Use
to a position away
attached to the glass unattended.
to
Control once and
Status Indicator
the Direction