ECOVACS ROBOTICS WINBOT X Bedienungsanleitung Seite 26

6. Troubleshooting
No. Malfunction
The robot's fan doesn't
after the Safety Pod has been
3
connected with WINBOT
attached to the window.
Remote Control cannot
4
WINBOT.
26
EN
Possible
work
Safety Pod malfunction
and
WINBOT is in sleeping mode
When WINBOT is cleaning, only the START/
PAUSE Button works
The Remote Control is not paired with
WINBOT (WINBOT arrives from the factory
paired with its Remote Control.
Control becomes un-paired or is replaced, it
control
can be re-paired).
WINBOT Status Indicator
continuous RED.
The batteries are not
Control or need to be replaced.
Causes
Check the Safety Pod Status Indicator
WINBOT,
Press the START/PAUSE
up.
Pause WINBOT by pressing the START/PAUSE Button on
the robot
on the Remote Control.
Control will function while WINBOT is paused.
Within the first 5 seconds of powering ON WINBOT, press
and hold START/PAUSE Button on WINBOT and Pairing
If the Remote button on the Remote Control at the same time. Pairing
is complete when START/PAUSE Button blinks RED and
BLUE and beeps.
Press
Light glows a
to initialize WINBOT, then the Remote Control will
function.
inserted in the Remote
Insert or replace the batteries in the Remote Control.
Solutions
and refer to Section 5 for details.
Button on WINBOT
or Remote Control. Other buttons
and hold the RESET Button on the
Light on the
to wake it
on the Remote
Remote Control