Num'axes PROTECTION PIE1069 Gebrauchsanleitung Seite 28

Cycle recording
IR LED brightness
Low power night
capture
Operating periods
Frequency
Time Lapse programmable from 00:00:05 up to 23:59:59.
Example: if Time Lapse is set to 00:30:00, the camera will
automatically capture photos/videos every 30 minutes.
The "Time Lapse" feature can work together with the
"Operating periods" feature.
OFF | ON
When the memory card will be full, the camera will
continue to record photos/videos by deleting the oldest
photos/videos.
Select "OFF" then press the OK button to deactivate the
cycle recording function.
Auto | Medium | Low | OFF
This parameter allows you to adjust the brightness of the
infrared flash
No IR flash | No capture
‒ No IR flash: At night, if the power level is too low (solar
panel battery, AA batteries), the device will take
photos/videos without triggering the infrared flash.
‒ No capture: at night, if the power level is too low (solar
panel battery, AA batteries), the device will no longer
take photos/videos.
OFF | ON
Each day, the camera will work only during the user set
time period(s). Two different periods can be programmed.
Select "ON" then press OK to set the start time (Hr:Min)
and end time (Hr:Min) of the desired working period(s).
Example: If "Period 1 – Start" is 15:00 and "Period 1 – End"
is 18:00; each day, the camera will work only between
15h00 (03:00 PM) and 18h00 (06:00 PM).
The "Operating periods" feature can work together with
the "Time Lapse" feature.
50 Hz | 60 Hz
An improper setting may cause the camera screen to
flicker.
Guide PIE1069 – Août 2025 – ind. C - 28/144