Num'axes PROTECTION PIE1069 Gebrauchsanleitung Seite 27

Settings
Mode
PIR interval
PIR sensitivity
Time Lapse
Programmable options
(default settings in bold characters)
Photo | Video | Photo + Video
− Photo: the camera will only shoot photos.
− Video: the camera will only shoot videos.
− Photo + Video: upon the same trigger event, the camera
will shoot photo(s) first then a video.
Default PIR interval: 20 seconds
Programmable from 5 seconds (00:05) to 59 minutes
59 seconds (59:59)
Allows you to set the desired time interval between
photos/videos upon motion detection by the PIR sensor.
Example: if the PIR interval is set to "01:00", the camera
will wait 1 minute between photo/video recordings with
motion.
High | Medium | Low
With the PIR sensitivity set to High, the PIR sensor:
‒ is more sensitive to movements by smaller subjects;
‒ offers longer detection distance;
‒ can more easily detect a difference between body
heat and outdoor temperature;
‒ can more easily trigger the camera.
In high temperature environment, subjects body heat and
environment temperature are hard to tell by the camera,
the suggested setting is high.
However, it is recommended to use low PIR sensitivity in
environments with lots of interference like hot wind,
smoke, near window, etc. This will prevent untimely
triggering
OFF | ON
With "Time Lapse" ON, the camera will capture photos or
videos automatically at a pre-set time interval.
WARNING: when the Time Lapse parameter is set to ON,
the PIR sensor is deactivated (there is no motion
detection).
Select "ON" then press OK to set the interval; the camera
will shoot photos or video clips automatically upon the
user set interval.
Guide PIE1069 – Août 2025 – ind. C - 27/144