Next Level Racing ERS3 HYPERCOOL Bedienungsanleitung Seite 18

Align the mounting slots on the Seat Brackets with the T-Nuts previously installed in Step 20. Bolt
22
through and secure with 4 x M8 Bolts and Washers.
A)
A) Lift the Seat Slider Lever and slide the Seat Rails all the way back to access the rear mounting slots
on the Seat Slider.
23
B) Align the Seat Slider rear mounting slots with the T-Nuts in the rear 4040 Extrusion that was
uninstalled in Step 16. Secure it to the Seat Sliders using M8 Low Profile Bolts.
A)
A) Lift the Seat Slider Lever and slide the Seat Rails all the way forward to access the front mounting
holes on the Seat Slider.
24
B) Align the Seat Slider front mounting holes with the T-Nuts in the front 4040 Extrusion that was
uninstalled in Step 16. Secure it to the Seat Sliders using M8 Low Profile Bolts.
B)
B)
18
NOTE: Leave Bolts hand tight to allow
adjustment in future steps.
NOTE: Partially tighten bolts
with fingers, then secure
using M6 Allen Key.
Repeat
on Other
Side
NOTE: Partially tighten bolts
with fingers, then secure
using M6 Allen Key.
Repeat
on Other
Side
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • 2 x Side Mount Seat Brackets
PARTS:
• • 1 x Rear 4040 Extrusion
• • 2 x M8 16mm Low Profile Bolts
• • 2 x M8 Spring Washers
Note: Use Spring Washers with M8
Low Profile Bolts when installing
Seat to the F-GT Elite Cockpit.
PARTS:
• • 1 x Front 4040 Extrusion
• • 2 x M8 16mm Low Profile Bolts
• • 2 x M8 Spring Washers
Note: Use Spring Washers with M8
Low Profile Bolts when installing
Seat to the F-GT Elite Cockpit.