Next Level Racing ERS3 HYPERCOOL Bedienungsanleitung Seite 14

A)
A) Align the Seat Slider rear mounting slots, with the T-Nuts in the rear 4040 Extrusion.
10
B) Bolt through and secure with M8 Low Profile Bolts.
A)
A) Lift the Seat Slider Lever up and slide the Seat all the way back to access the front mounting holes.
11
Align the Seat Slider front mounting holes with the T-Nuts in the front 4040 Extrusions.
B) Bolt through and secure with the M8 Low Profile Bolts.
12
Your installation is complete on the Elite Series Cockpit.
B)
NOTE: Partially tighten bolts with
fingers, then secure using M6
Allen Key.
Repeat
on Other
Side
B)
NOTE: Partially tighten bolts with
fingers, then secure using M6
Allen Key.
Repeat
on Other
Side
14
PARTS:
• • 2 x M8 16mm Low Profile Bolts
• • 2 x M8 Spring Washers
Note: Use Spring Washers with M8
Low Profile Bolts when installing
Seat to the F-GT Elite Cockpit.
PARTS:
• • 2 x M8 16mm Low Profile Bolts
• • 2 x M8 Spring Washers
Note: Use Spring Washers with M8
Low Profile Bolts when installing
Seat to the F-GT Elite Cockpit.
PARTS:
• • NIL