DUROFIX RV2053-WR45 Produktinformationen Seite 21

E011 Lockout time
too long
E012 Over Torque
E999 Wrong
password
Note:
if troubleshooting doesn't work, call authorised service centre.
NOTE
Only do tool and receiver be pairing during both set on the same Group and ID. Do not set
all tools or receivers on the same one Group and ID. More than two tools or receivers setting on the same
one Group and ID means they are in the same channel and users could not tell which signals come from
which tools.
NOTE
Continuous use in variable speed range is not recommended. It may damage the switch and
should be avoided.
NOTE
When change the position of the control button, making sure the variable speed switch is
released.
NOTE
The first time the tool is run after changing the direction of rotation, you may hear a click
on start up. This is normal and does not indicate a problem.
WARNING
NOTE
This tool is lubricated before it leaves the factory. This lubrication should last for the life of
the tool. No further lubrication is required.
DANGER
exclusive JIGS plus testers, and trained techniques. Incorrect disassembly, reassembly or adjustment can
cause not only insufficient power but also accidents. Ask for these services from an authorized service
centre. The maker or supplier will not be held liable for any damages caused by factors found to be the
cause of faulty use or repair by users or unauthorized service provider.
CLEANING
1English1
1. Change Battery
2. Adjust tool setting. Current setting is not suit for the
working joint type
3. Electronic fault, Call service centre
1. Adjust tool setting. Current setting is not suit for the
working joint type
2. Electronic fault, Call service centre
1. Re-enter correct passward
2. Call service centrefor password resetting
MAINTENANCE
Remove the battery pack from this tool before cleaning solutions.
A battery pulse tool is a precision tool. Disassembly, assembly, adjustment require
English -20- -20