DUROFIX RV2053-WR45 Produktinformationen Seite 10

INSTALLING THE SOCKET ONTO ANVIL
(1) Press down the fixing pin (1) in the direction shown by the arrow (Fig. 4).
(2) Insert the socket into the anvil, and then release the fixing pin to secure the socket.
Note:
If the fixing pin is not pressed deep enough, the socket will not be able to fit into the anvil smoothly,
or the fixation will not be firm enough. In this case, try reinstalling according to the instructions above.
Note:
Before installing or removing the socket, be sure to set the control push the F/R lever to the middle
position to prevent accidentally pressing the switch to start. The socket must be in compliance with ISO
specifications. The side fixing hole size is as follows. It is recommended to use a 7.9mm socket (Fig. 5).
Using a socket that does not comply with ISO specifications will not be able to be reliably fixed on the anvil
of the tool.
1English1
B
A
Fig. 3
(1)
(2)
Fig. 4
Fig. 5
English -9- -9