Height Adjustment - Timago Dualtim Benutzerhandbuch

3. Assembly and adjustment
• To assemble the rotor, join the two parts of the frame together and then
twist them together using the angle adjustment knob (longer thread),
placing the oblong washer beforehand.
• Insert the locking pin into the frame holes to secure the set angle of the
pedal exerciser frame.
• Place the counter onto the moun�ng hole in the top of the frame.
• Screw the resistance adjustment knob (shorter thread) into the moun�ng
hole in the top of the frame.
• To assemble the pedal exerciser, follow the above instruc�ons in reverse
order.
• To dismantle the counter or replace the batery in the counter, unscrew the
adjustment knob completely and then dismantle the counter and/or replace
the batery.
• To replace the batery, open the top cover of the counter by grasping the
lower protruding part of the cover under the red MODE buton.
ATTENTION: When replacing the batery, all data will be lost.

HEIGHT ADJUSTMENT

The pedal exerciser is height-adjustable to suit the individual user's needs. There
are 6 adjustment holes at the base of the pedal exerciser for height adjustment.
The largest base spacing is the minimum height of the exerciser, the smallest
spacing is the maximum height.
• Before changing the height adjustment, loosen the angle adjustment knob.
• Then press the locking pin and adjust the desired pedal exerciser base
spacing. A�er adjustment, the locking pin should lock the selected se�ng.
• A�er changing the height adjustment, �ghten the angle adjustment knob.
CHANGE OF PEDALS INTO HANDLES / HANDLES INTO PEDALS
The pedal exerciser is used for both lower and upper limb exercises
(interchangeable). When changing the func�on of the pedal exerciser, it is
necessary to change the pedals into handles (or handles into pedals) according to
the following instruc�ons:
• Unscrew the pedal lock (the locking handle allows it to be unscrewed
without the need for addi�onal tools).
• Replace pedal to handle (or handle to pedal).
• Tighten the pedal lock (the lock handle allows it to be unscrewed without
the need for addi�onal tools).
• Swap the other pedal/handle in a similar manner.
32