Getting Started; Power Supply; Initial Operation; Starting The Instrument - Pce Instruments Pce-Tg 300 Bedienungsanleitung

4

Getting started

4.1

Power supply

To establish power supply, four AA Alkaline
located at the rear side of the meter and is affixed with two screws. Loosen the screws, remove the
cover, insert the batteries as illustrated and close the battery cover again by tightening the screws.

Initial operation

4.2

Starting the instrument

4.2.1
To start the meter, press
language can be set by using the Fl
To switch off the meter, press and hold
automatically load these when it is switched on again. Even when the batteries
settings will remain saved.

System Configuration

4.2.2
The following settings can be found in the sub-menu „System
Configuration".
path: F3 Setup —+Main menu
v A System Configuration
F3 0 Confirm
Description
Function
Bluetooth Off / Slave
Ke Sound On / off
Warn Sound On / off
LCD Display brightness setting (0 ... 100 %)
Bri htness
Display Delay time setting
Standb 5 s/
Power off delay time setting
Auto
Poweroff 2 min / 5 min / 10 min / deactivate
Unit S stem mm / inch
Date and time setting
Date / Time
Set
Lan ua e En lish / German
batteries are needed.
until the display reacts. While the device loads the software,
key. After loading, the meter will display the main screen.
for 2 seconds.
mode / Master mode
15 s / 30 s/ 1 min / 2 min
/ French / S anish
O PCE
The battery compartment
The meter will save all settings
System
Bluetooth
Key Sound
am Sound
LCD Brightness
Display Standby
o Poweroff
/ deactivate
/ltalian
Instruments
22
is
the
and
are removed, all
Configuration
On
On
100%
2 Minute
2 Minute
It