Getting Started; Power Supply; Preparation; Menu - Pce Instruments Pce-Btm 2000A Bedienungsanleitung

4

Getting started

4.1

Power supply

Three AA alkaline batteries are required for power supply. The battery compartment is located on
the back of the meter and is secured with two screws. Loosen the screws, lift off the cover, insert
the batteries as indicated and close the battery compartment by tightening the screws. Before
replacing the batteries, turn off the instrument.
4.2

Preparation

Before switching on the instrument, insert the sensor head into the sensor socket of the meter and
fix the head by tightening the knurled nut. To start the instrument, press the On/Off key
instrument name appears on the display. To switch off the meter, press the On/Off key
display turns off. When the unit is switched on, the measuring mode
together with a hand icon. Before first use and after each battery change, you should set the date
and time (see 5.2.2). To enter measuring mode, press the Measuring mode key
to make settings, press the Menu key
5

Menu

You can enter the menu of the meter by pressing the Menu key
starting the meter. You can navigate through the menu with the arrow keys
. With the OK key
Back key , you can navigate one step back.
5.1

Force

In the submenu "Force", you can enter the values required to measure the
trum force. You can also choose whether or not the trum force will be
displayed in measuring mode.
to enter the menu.
, you can confirm your selection. With the
© PCE Instruments
20
until the
until the
icon appears on the display
. If you would like
after