Further Functions - Pce Instruments Pce-Tg 300 Bedienungsanleitung

5.3 Measurement
Procedure:
1. Before starting a measurement,
2. set the work mode in line with the criteria described
3. Apply some coupling gel to the workpiece.
4. Evenly press the probe onto the workpiece
should now be displayed in white letters).
5. If a correct measurement
press the probe onto the workpiece. If the problem persists, try a different probe (different
size/ frequency).
6. If desired, you can save the measured value, as described in chapter 5.4.4.
7. Four measurements
remain displayed.
5.4 Further functions
5.4. I View Mode
You have three different options to view measured
mode
Normal mode:
In normal mode, only the current material thickness value will be displayed.
Scan mode:
In scan mode, the material thickness value will be displayed as
in normal mode. In addition,
values will be displayed.
canbereset b ymeans oftheOn/off k eyA.
Difference mode:
In this mode, the material thickness value is displayed
thickness To.
The nominal thickness To of the workpiece
advance. To do so, go to the main menu by pressing F3
and select "Test Settings" where you can find the "Nominal
Thickness" setting. You can select the decimal place with Fl
and F2 and with v
thickness. Confirm your entry with F3
carry out a calibration
(the coupling status and material thickness value
is not possible, double-check
per second are made. When the probe is removed, the last reading will
the minimum
The minimum and maximum
must be set in
A
you can set the nominal
O PCE
(5.2).
in chapter 5.1.
the coupling gel and evenly and firmly
values: normal mode, scan mode, difference
P-E
14.76
and maximum
values
14.75
FOO:02
PRINT
along with the difference
P-E
15.15
0=10.00
FOO:02
PRINT
Instruments
26
P5EE V-5865
14.82
16:06
PROBE SETUP
to the set nominal
P5EE V=5954
A5.1
16:01
PROBE SETUP