Getting Started; Power Supply; Power On/Off - Pce Instruments Ram 100 Bedienungsanleitung

4

Getting started

4.1

Power supply

The PCE-RAM 100 radiation meter is powered by an internal rechargeable LiPo battery. With a
fully charged battery, an operating time of approx. 8 hours is possible, depending on the
brightness of the display and the use of the data logger. The battery is charged via the C-type
USB socket at the bottom of the meter, using a suitable USB charger.
The current charge level of the battery is displayed in the status bar at the top right-hand side of
the screen. As soon as the charge level of the battery is no longer sufficient for proper operation
of the instrument, it switches off automatically and the screen shown below is displayed.
4.2

Power on/off

The meter is switched on by pressing the ON/OFF key. When the device is switched on, the start
screen appears for approx. 1 second and then the device enters the measurement screen. To
switch off the meter, press and hold the ON/OFF key. A dialogue with a countdown now appears
on the display to announce that the instrument is about to power off.
© PCE Instruments
31