PCE Instruments PCE-TG 300 Bedienungsanleitung Seite 30

Limit value setting
5.4.2
In order to see whether
the tolerance, a top limit and a bottom limit can be set. When
the limits are exceeded / fallen below, the reading will be
shown in red instead of green when the probe is removed. To
set the limit values, go to the main menu with F3
and select "Test Settings". Here, you can find the settings
"Bottom Limit" a nd"TopLimit". W ithFl
can select the decimal place and the limit can be set with v
A . Confirmyour entry with F3
5.4.3 Resolution
You can select one of these three resolutions:
the surface of the workpiece
is recommended. To set the limit values, go to the main menu with F3
. Settings" Here, y oucanfindtheresolution setting. Select thedesired resolution withF20. Confirm
yourentry withF30.
5.4.4 Memory Manager
Save
When you press the Save
last data record.
View
The saved data records can be viewed on the meter's display.
To view these records, go to the main menu with F3
and select "MemoryManager".With the v A keys, you can
navigate t o thedatasetandselect i t bypressing F 30. Inthe
data set, all data records
individually by pressing F3
Select data set
To select a data set, go to the main menu by pressing F3
Setup and select "Memory Mana er" where you can navigate
to the desired data set with the
In the menu that opens, select "Set". The readings will now be
saved to the data set. In the menu, you can also delete the
sets or an individual set.
the material thickness value
andF20,
should be very smooth. When the surface is coarse, a low resolution
key, the current reading will be saved to the selected data set as the
are shown and can be deleted
or completely by pressing F2
A keys and press F2
O PCE
is within
elocity Set
lew Mode
Nominal
Setup
Bottom Limit
Top Limit
Resolution
you
0.1 mm / 0.01 mm / 0.001. If you select 0.001 mm,
View
No. 1
Setup
No.2
• FOO
FOI
F 02
F03
F 04
F 05
Instruments
27
Test Settings
5954m/s
Diff Mode
Thickness 10.00mm
0.20mm
610.00mm
0.01mm
Setup and select "Test
Record Data-FOO
14.96mm
4.01 mm
Memory Manager
2/100
0/100
0/100
Set
oo
Clear
00
Clear All
oo
print
Print All