Parkside PPM 1200 A1 Bedienungsanleitung Und Originalbetriebsanleitung Seite 12

˜ Safety warnings for
polishing
1) This power tool is intended
to function as a polisher.
Read all safety warnings,
instructions, illustrations and
specifications provided with this
power tool. Failure to follow all
instructions listed below may result
in electric shock, fire and/or serious
injury .
2) Operations such as grinding,
sanding, wire brushing, hole
cutting or cutting‑off are not to
be performed with this power
tool. Operations for which the
power tool was not designed may
create a hazard and cause personal
injury .
3) Do not convert this power
tool to operate in a way which
is not specifically designed
and specified by the tool
manufacturer. Such a conversion
may result in a loss of control and
cause serious personal injury .
4) Do not use accessories which
are not specifically designed
and recommended by the tool
manufacturer. Just because you
can attach the accessories to your
power tool does not guarantee they
are safe to use .
5) The rated speed of the accessory
must be at least equal to the
maximum speed marked on the
power tool. Accessories running
faster than their rated speed can
break and fly apart.
6) The outside diameter and the
thickness of your accessory must
be within the capacity rating of
your power tool. Incorrectly sized
accessories cannot be adequately
guarded or controlled .
7) The dimensions of the accessory
mounting must fit the dimensions
of the mounting hardware of the
power tool. Accessories that do
not match the mounting hardware
of the power tool will run out of
balance, vibrate excessively and
may cause loss of control .
8) Do not use a damaged
accessory. Before each use
inspect the accessory such as
abrasive wheels for chips and
cracks, backing pad for cracks,
tear or excess wear, wire brush
for loose or cracked wires.
If power tool or accessory is
dropped, inspect for damage or
install an undamaged accessory.
After inspecting and installing
an accessory, position yourself
and bystanders away from the
plane of the rotating accessory
and run the power tool at
maximum no-load speed for one
minute. Damaged accessories will
normally break apart during this
test time .
9) Wear personal protective
equipment. Depending on
application, use face shield,
safety goggles or safety glasses.
As appropriate, wear dust mask,
hearing protectors, gloves
and workshop apron capable
of stopping small abrasive or
workpiece fragments. The eye
protection must be capable of
stopping flying debris generated
by various operations . The dust
mask or respirator must be capable
of filtrating particles generated by
your operation . Prolonged exposure
to high intensity noise may cause
hearing loss .
GB 11