Astralpool All In one Control Connect Schnellstartanleitung Seite 3

EN
The short manual included with this product only contains essential information on safety
!
measures that must be implemented during installation, maintenance and start-up.
NOTICE
The complete manual can be read and downloaded as a PDF file using the QR or from the
following website: www.astralpool.com. All assembly, electrical installation and maintenance
tasks are to be carried out by authorised, qualified technicians who have carefully read all the
installation and service instructions.
GENERAL CHARACTERISTICS
- Smart controllers make maintenance and monitoring of the pool efficient and cost-effective.
- Compatible with saline electrolysis systems.
- Maintaining a certain level of chlorine in the pool water guarantees its quality.
- The controller will release doses of chlorine when the pool's filtering system (pump and filter) are running.
- The equipment has several safety devices, which are activated in the event of abnormal system operation, as well
as a control micro-controller.
- These control systems integrate automatic pH and ORP controllers which are activated according to need.
SAFETY WARNING AND RECOMMENDATIONS
- Installation and manipulation must only be performed by suitably qualified technicians.
- Applicable standards for accident prevention and for electrical installations must be observed.
- During installation, bear in mind that electrically disconnecting the equipment requires a switch or circuit breaker
according to standards IEC 60947-1 and IEC 60947-3 which ensures an omnipolar cut-off, directly connected to the
power supply terminals and with a contact separation in all poles, providing total disconnection under overvoltage
category III conditions, in an area that fulfils the safety requirements of the site. The switch must be located in the
immediate vicinity of the equipment and must be easily accessible. Additionally, it must be marked as the equipment's
disconnection element.
- The equipment must be powered through a residual current device (RCD) not exceeding 30mA. The equipment
must be earthed.
The installation must comply with the requirements of IEC / HD 60364-7-702 and national standards applicable to
swimming pools.
- Under no circumstances will the manufacturer be held responsible for the assembly, installation or initial start-up, nor
for any manipulation or addition of components other than when carried out at the manufacturer's premises.
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental ca
pabilities, or who lack experience or knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do
not play with the appliance.
- The system operates at 230 Vac – 50 Hz. Do not attempt to alter the control unit to operate at any other voltage.
- Ensure that all electrical connectors are properly tightened, to avoid bad connections leading to overheating.
- Before installing or replacing any component in the system, ensure that it is disconnected from the power supply and
no water is flowing through it. Only use genuine replacement parts.
- Install the equipment in a well-ventilated location, preferably not in the vicinity of flammable products.
- Never install it in areas at risk of flooding.
- This device is equipped with a mounting bracket; see installation instructions.