Astralpool Control Connect Schnellstartanleitung Seite 3

EN
!
NOTICE
GENERAL CHARACTERISTICS
-Smart controllers make maintenance and monitoring of the pool efficient and cost-effective.
-Compatible with saline electrolysis systems.
-Maintaining a certain level of chlorine in the pool water guarantees its healthiness.
-The controller will release doses of chlorine when the pool's filtering system (pump and filter) are running.
-The equipment has several safety devices, which are activated in the event of abnormal system operation, as well
as a control micro-controller.
-These control systems integrate an automatic pH, ORP and PPM controller which adjusts these values according to
need.
SAFETY WARNING AND RECOMMENDATIONS
-Installation and manipulation must only be performed by suitably qualified technicians.
-Applicable standards for accident prevention and for electrical installations must be observed.
-During installation, bear in mind that electrically disconnecting the equipment requires a switch or circuit breaker
according to standards IEC 60947-1 and IEC 60947-3 which ensures an omnipolar cut-off, directly connected to the
power supply terminals and with a contact separation in all poles, providing total disconnection under overvoltage
category III conditions, in an area that fulfils the safety requirements of the site. The switch must be located in the
immediate vicinity of the equipment and must be easily accessible. Additionally, it must be marked as the equipment's
disconnection element.
-The equipment must be powered through a residual current device (RCD) not exceeding 30mA. The equipment must
earthed.
-Under no circumstances will the manufacturer be held responsible for the assembly, installation or initial start-up, nor
for any manipulation or addition of components other than when carried out at the manufacturer's premises.
-This appliance may be used by children aged 8 years or older and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge, as long as they are supervised or have received suitable instruction
on how to use the appliance safely and understand the hazards involved. Children must not play with the appliance.
Cleaning and user maintenance must not be carried out by children without supervision.
-If the power cable is damaged, it must be replaced by the manufacturer, by their after-sales service or by equivalent
qualified technicians in order to avoid any type of danger.
-The system operates at 230 Vac – 50/60 Hz. Do not attempt to alter the control unit to operate at any other voltage.
-Ensure that all electrical connectors are properly tightened, to avoid bad connections leading to overheating.
-Before installing or replacing any component in the system, ensure that it is disconnected from the power supply and
no water is flowing through it. Only use genuine replacement parts.
-Given that the equipment generates heat, it is important to install it in a properly ventilated area. Do not install near
flammable materials.
-Despite the equipment having an IP32 protection rating, it must never be installed in areas at risk of flooding.
-This equipment is intended to be permanently connected to the water supply and should not be connected using a
temporary hose.
-This device is equipped with a mounting bracket; see installation instructions.
The short manual included with this product only contains essential information on safety
measures that must be implemented during installation, maintenance and start-up.
The complete manual can be read and downloaded as a PDF file using the QR or from the
following website: www.astralpool.com. All assembly, electrical installation and maintenance
tasks are to be carried out by authorised, qualified technicians who have carefully read all the
installation and service instructions.