Manufacturer's Address; Disassembly And Disposal; Conformity Declaration; Energy Efficiency - Elero Roltop Nutzungsinformation

Relief function | End position settings
• Surrounding circumstances
• Own assumption
9

Manufacturer's address

After installing the drive, the R+S mechatronics technician
(roller shutter and sun protection mechatronics technician)
must note the installed type of drive and the installation
location in the installation and operating instructions.
Drive designation
____________________
____________________
____________________
If malfunctions occur despite proper handling or if the unit
has been damaged, contact your contract partner.
elero GmbH
Drive technology
Maybachstr. 30
73278 Schlierbach
Deutschland / Germany
Please visit our website if you require a contact partner
outside Germany.
10

Disassembly and disposal

Dispose of the packaging according to current regulations.
Dispose the product after previous use in accordance with
applicable regulations.
Environmental information
No unnecessary packaging was used. The packaging can
be easily divided into three material types: Cardboard (box),
Styrofoam (padding) and polyethylene (bag, foam material
protective foil).
The device is made up of materials that can be reused if it
is disassembled by a specialist operation. Please observe
the local provisions on disposal of packaging material and
old devices.
Always expect additional danger that does not occur in
operation during disassembly.
WARNING
Danger of injury due to electric current.
Electric shock possible.
►Physically disconnect power supply lines and discharge
charged energy storage. Wait for at least 5 minutes after
deactivation for the motor to cool down and the capaci-
tors to lose their voltage.
►Use suitable, tested and stable climbing aids when per-
forming disassembly work above body height.
►All work at the electrical system must only be performed
by the staff described in the chapter "Safety instructions
for electrical installation".
Scrapping
During the scrapping of the product, the international,
national and regional-specific laws and regulations are to be
complied with.
Installation location
(e.g. living room window 2)
_________________________
_________________________
_________________________
Tel: +49 7021 9539-0
Fax: +49 7021 9539-212
info.elero@niceforyou.cm
www.elero.com
© elero GmbH
Please make sure to consider material recyclability, ease of
dismantling, and separability of materials and components
as well as environmental and health hazards during recy-
cling and disposal.
CAUTION
Environmental damage at incorrect disposal
►Electronic scrap and electronic components are subject
to the hazardous waste rules and must only be disposed
of by approved specialist operation.
►Groups of materials such as plastics and metals of vari-
ous kinds are sorted for recycling and disposal process.
Dispose electrical and electronic components
Disposal and recycling of electric and electronic compo-
nents must comply with the applicable national laws and
regulations.
11

Conformity Declaration

elero GmbH hereby declares that this product corresponds
to the applicable directives. The complete declaration of
conformity can be found under
www.elero.com/en/downloads/downloads-service/
12 Energy efficiency
The drive remains below the legally required consumption
values of the European Ecodesign Directive 2023/826.
After the main function 'raising' or 'lowering' (active mode)
has ended and the roller shutter switch is left in the UP or
DOWN position, the power consumption is less than 0.3 W
(standby mode). There is no power consumption when the
switch is in the 'OFF' position.
13

Technical data and dimensions

The indicated technical data are subject to tolerances (ac-
cording to the respective applicable standards) and refer to
an ambient temperature of 20 °C.
After installing the drive, the roller shutter and sun protec-
tion mechatronics technician must note the installed type
of drive and the installation location in the installation and
operating instructions.
EN | 7