Exchange Of The Spiral Shaft - Eberth Gb1-R760Eq Bedienungsanleitung

Exchange of the spiral shaft

The device has a quick change device for the spiral shaft.
• Before replacing the spiral shaft, check that the battery is removed.
• Set the operating handle to the 0-position.
• Lead the spiral shaft out until the connecting piece appears.
• Loosen the M4 screws with an Allen wrench.
• Remove the old spiral shaft (Fig. 1 1 next page).
• Insert the new spiral shaft into the connector.
• Align the threaded holes and tighten the M4 screws.
• Push the spiral shaft into the drum manually.
Never switch on the device to retract the spiral shaft. The free spiral shaft can
cause unpredictable injuries, tool damage, damage to internal objects, fire,
electric shock and other dangerous situations.
• If the spiral shaft cannot be replaced normally, contact our customer service.
• After each use, manually turn the drum until the waterproof nipple comes out from
under the casing.
• Unscrew the waterproof nipple with an Allen wrench (Fig.12).
• Straighten the device upside down so that liquid can run off in the drum.
EN V. 1.0
Green
Fig.10
19