EBERTH GB1-R760EQ Bedienungsanleitung Seite 44

ON
• Press the forward/backward switch to position L.
• Press the on/off switch lightly.
• Move the handle forward to the F-position.
• The spiral shaft is output to the front. The pipe cleaning process begins
• Insert the spiral shaft into the pipe until you feel resistance.You have reached the
congested area.
If the spiral shaft stops at an obstacle or pipe bend, pull the handle back to retract the
spiral shaft a certain distance. Then pull the handle forward again to move the spiral
shaft forward again.
• Operate the operating handle back and forth repeatedly to clean the pipe and get
through pipe bends.
Risk of injury!Never force the spiral shaft to move forward. The spiral shaft will
knot or break and may cause serious injury.Work carefully!
If the blockage is too persistent, use the following two methods:
A
• Turn the clamping ring counterclockwise to obtain a greater driving force.
• Observe the condition of the spiral shaft closely.
• Press the on/off switch lightly-
• If the spiral shaft is blocked, twisted or knotted, release the on/off switch immediately
and stop the rotation.
B
• Move the handle to the F- and 0-position
• Clean the pipe carefully according to the situation.
To see if the pipe has been cleaned or if cleaning has not been carried out, turn the
clamping ring clockwise, release the jaw and pull back the spiral shaft by clamping
force.
EN V. 1.0 17