Flysurfer Speed4 Lotus Bedienungsanleitung Seite 61

Disconnect the front and steering
lines on one side. Undo the short line
pieces at the mixer.
Pull the old Sparepart Lines out of
the pulley. Always exchange both lines.
When exchanging a pulley (after
250h of use) concentration is needed.
First make a larks head at the end
of the line.
Put the pulley through the loop.
Pull the larks head knot tight.
Make sure to attach the new spare-
part line in the same way as the old one.
The long sparepart line has a
knot at the end, this knot is the-
re to block the pulley from sliding
over. Now pull the ring through the
loop and attach to the flying line.
Redo the short line pieces and
pull the knots tight.
Reconnect the flying lines again,
and then repeat the same proce-
dure on the other side. Pull all knots
tight and check the bridle carefully.
Warning: After exchanging
the sparepart lines, do a
mixertest and adjust the
mixer accordingly.
61
EN