Drainage - Flysurfer Speed4 Lotus Bedienungsanleitung

54
EN

07.03 Drainage

Flysurfer kites feature a water/dirt
drainage system. This ensures that
water or dirt are automatically removed
and do not stay trapped inside the kite.
If the kite is lying ready for
launch in the powerzone, you only
have to depower the kite to let it
launch. The air flowing into the kite
will push out any water or dirt.
If the kite does not lift up
and peel to one side when
pulling the leader line, try
pulling the opposite leader
instead. If this still does not
work, then use the reverse
launch method.
If the kite is lying on its leading
edge, it has to be turned upright onto
its side. Try to achieve this by pulling
on one Steering Line. Try to prevent
the upper wingtip from collapsing.
You can prevent this by pulling on
the downwind side of the bar or
the corresponding Leader Line.
The excessive water/dirt should
now flow out of the tip until it is
ready to be launched again. This
method must be done with feeling
and requires some practice.
Tip: If you do not drag the
kite through the water, it will
still be possible to relaunch
it even after 30 minutes if
there is enough wind.