Selve commeo Control Betriebsanleitung Seite 34

EN
Explanation of functions/terms used
5. Explanation of functions/terms used
Local operation
Local operation means the manual operation of drives directly by the
user. The local operation can be done directly at the commeo Control
or also via the extended local extension. A local operation is possible
in the manual but also in the automatic service of the drive.
• Standard moving commandos: UP , STOP, DOWN
• Moving to the intermediate position 1 (double tap DOWN)
• Moving to the intermediate position 2/changing position (double
tap UP)
Group operation
Group operation means the control of the drives via automatic signals
(e.g. switching times, sensor commandos etc.) Furthermore group
operations can be released via the group extension entrances. The
difference to the local operation is that the group operation can only
be executed in the automatic service of the drive.
Manual/automatic sliding switch
The sliding switch enables the changeover between the manual and
the automatic operation. In the sliding switch position MAN only
manual moving commands will be executed (e.g. UP , STOP , DOWN
via push button on the device or via radio).
Alarm signal
There is an alarm signal when there is a permanent switching signal
for longer than 5 seconds at the extension (local or group entrance).
An existing alarm signal will be signalized by the status LED and be
switched on or rather switched off by the setting.
Roller shutter/blind operation
The setting roller shutter / blind operation enables the electively con-
necting of a tap operation in order to allow an exact positioning of the
slats of blinds. When the blind operation is selected, the recognition
of a possible double tap for the moving of the set intermediate posi-
tion will take place in the first 0,5 seconds. After that a tap operation
in moving direction will take place for 1 second before after 1 second
the automatic mode will begin.
34