Selve commeo Control Betriebsanleitung Seite 31

Installation
4.2. Connection as a group controller
When the commeo Control will be used as a group control device,
the exit of the device provides the control signal for further group/
drive control devices. This function enables a wired networking of
several devices.
The following connection diagram shows the extended, wired net-
working of several commeo Control via a potential-free exit.
Note: The extensions of the commeo Control are compatible with the
SELVE devices i-Control, i-Timer Plus, i-R Control.
Motor controller
Extended local UP
Extended local DOWN
GND
Group UP
Group DOWN
commeo Control
Extended local UP
Extended local DOWN
GND
Group UP
Group DOWN
commeo Control
Group controller
31
Mains voltage (230 V)
Small signal voltage (5 V)
EN
EN