Heyner MaxiProtect Comfort Bedienungsanleitung Seite 6

MBH
HEYNER
GMBH
English
Group II + III (Age about 4 to 12 years, child´s weight 15 to 36 kg)
Index / page
HEYNER ® MaxiProtect Comfort as a child car seat
1. Using the HEYNER
2. GROUP II+III (about 15 to 36 kg)
3. Care Instructions
4. Important Notices
5. Some final fints
Operating Instructions
A Connecting hooks
B Fitting holes O Lap belt of the three-point-
C Fixation lugs for three-point belt vehicle-belt
D Headrest P Belt latch of the three-point-
E Belt guide vehicle-belt
F Belt Block anchor Q Belt buckle of the three-point-
N Diagonal belt of the three-point- vehicle-belt
vehicle-belt
www.heyner-germany.de
7
HEYNER ® MaxiProtect Comfort as a child car seat
1. Using the HEYNER
®
You have purchased the HEYNER HEYNER
MaxiProtect Comfort car seat for your child. We thank you
S. 8
for your trust. Please note, that the optimum safety characteristics can only be achieved if the
S. 8
seat is used properly according to instructions. Therefore we ask you to ensure the correct
S. 11
installation of the seat in your vehicle by reading the operating instructions carefully. Please
keep instructions always with the seat for further information.
S. 11
Only to be assembled by adults!
S. 12
Attention:
®
Only use the HEYNER HEYNER
MaxiProtect Comfort backrest in combination with the
®
HEYNER HEYNER
MaxiProtect Comfort booster. The backrest must not be used alone, as it doesn't
guarantee any safety. To get maximum side protection in an accident, use the backrest for
Group II+III consistently.
2. GROUP II+III (about 15 to 36 kg)
2.1. Connecting the backrest to the booster seat (fig.1-3) (just if non-assembled)
If backrest (fig.1) and booster (fig.2) are delivered in a non-assembled way, please follow these
instructions to connect both together before using it for children in group II.
Lay down the booster (fig.2) on the floor and the backrest (fig.1) flat right behind. Then thread
the connecting hooks (A) on the bottom of the backrest into the fitting holes (B) on the back of
the booster with a firm downwards motion. Now bring the backrest slowly upright, 90°to the
booster.
The connecting hooks should now slip into the fitting holes with an audible sound. As the result
the backrest should be well fixed to the booster in the upright position. It must not slip away
now. Otherwise you may not have fixed it very well an using it would be dangerous. In this case
lease repeat the first steps of this part of the instruction.
www.heyner-germany.de
English
GB
8