Parkside PERT 550 C6 Bedienungsanleitung Seite 12

Before commissioning and after any
impacts, check the product for signs
of wear and damages, and have any
necessary repairs performed.
Use only approved extension cords
(H05VVH2-F) that are not more than
75 m long and designed for outdoor
use. Always roll the extension cord
completely off the cable drum before
use. Check the extension cord for
damage and ageing.
Do not connect a damaged cable
to the mains supply. Do not touch a
damaged cable before it has been
disconnected from the mains supply,
as you could come into contact with
live parts.
Prior to use, check the mains cord
and extension cord for signs of
damage or ageing. If the cord is
damaged during use, disconnect
it from the mains immediately. DO
NOT TOUCH THE CORD BEFORE IT
HAS BEEN DISCONNECTED FROM
THE MAINS SUPPLY. Do not use the
product if the cord is damaged or
worn.
To unplug the mains cord from the
socket, always pull on the mains
plug, and never on the mains cord.
If the supply cord is damaged,
it must be replaced by the
manufacturer, its service agent or
similarly qualified persons in order to
avoid a hazard.
Operation
WARNING!
m
Do not touch any moving
u
dangerous parts before the
product has been unplugged from
the mains supply and the moving
dangerous parts have come to a
complete stop.
12 GB/IE/NI
Keep the connecting cable and
extension cable away from the
cutting device to avoid damages to
the cords which can lead to contact
with live parts.
Wear safety goggles, stable shoes
and long trousers over the entire
period of use of the product.
The use of the product under bad
weather conditions, especially
in case of lightning risk, must be
avoided.
There is a risk of injury from cuts on
hands and feet.
Stop using the product when
persons, above all children, and
house pets are in the vicinity.
Use the product only in daylight or
with good artificial lighting.
Always keep your hands and feet
away from the cutting equipment,
above all when you switch the motor
on.
Never replace the non-metallic
cutting device with a metallic cutting
device.
Never use the product with damaged
or missing protective equipment or
covers or if the cord is damaged or
worn.
Avoid an abnormal body posture.
Ensure secure footing at all times to
maintain balance when working on
slopes.
Go slowly. Do not run with the
product in your hand.
In the case of an accident or
malfunction during operation, switch
off the product immediately. Injuries
must be properly treated or medical
assistance sought.
Read the "Troubleshooting" section
to correct any malfunctions or
contact our customer service.