Scheppach AB1900 Originalbetriebsanleitung Seite 19

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this device assumes no lia-
bility for damage to the device or caused by the device
arising from:
• Improper handling,
• Non-compliance with the operating manual,
• Repairs carried out by third parties, unauthorised
specialists,
• Installing and replacing non-original spare parts,
• Improper use,
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed.
Our recommendation to you:
Read the whole text of the operating manual before as-
sembly and commissioning.
These operating instructions should help to familiarise
you with the machine and to use it for its intended pur-
pose.
The operating instructions include important instruc-
tions for the safe, proper and economic operation of
the machine, for avoiding danger, for minimising repair
costs and downtimes and for increasing the reliability
and extending the service life of the machine.
In addition to the safety instructions in these operating
instructions, you must also observe the regulations ap-
plicable to the operation of the machine in your coun-
try.
Keep the operating manual at the machine in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The machine may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards. The required
minimum age must be observed.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1-5)
1. Motor housing
2. On/off switch
3. Handle
4. Oil filling opening/sight glass
5. Additional handle
6. Tool receiver
7. Pointed chisel
8. Locking bolts
9. Clamping screw
10. Locking switch
11. Self-tapping screw
3. Scope of delivery (Fig. 6)
(1x) Demolition hammer
(1x) Transport case (A)
(1x) Oil bottle (B)
(1x) Pointed chisel ø 30 L390 (C)
(1x) Flat chisel ø 30 L390 (D)
(1x) Operating manual
• Open the packaging and carefully remove the de-
vice from the packaging.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating instructions before using for the first
time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your de-
vice.
www.scheppach.com GB | 19