Create Fire Tube Heater Bedienungsanleitung Seite 7

• This heater will become very hot, do not move it during operation.
• Keep children and pets away.
• Place the heater where it is visible and does not pose a tripping hazard.
• Place the heater on a level and safe surface, away from flammable items such as wooden fences or overhang-
ing tree branches.
• An adult must always be in charge of the heater. Never leave a hot heater unattended.
• Be careful of sharp edges during assembly.
• Always ensure that the heater is completely switched off and completely cool before fitting any covers (not
included) or storing the heater. Remember that the fuel may remain hot for some time and may re-ignite under
certain conditions unless it is fully extinguished.
• Attention! Never store a heater indoors unless all fuel has been completely removed and disposed of outside
and all surfaces of the heater have been cleaned and are cool, otherwise a fire and/or poisonous gas emis-
sions may occur which could cause death.
T Y PE AN D STO R AGE OF WOO D PE L L E T S
• Wood pellets can be purchased in many cooker, fireplace and agricultural shops. Look for pellets that meet
the "ENplus A1" standard. This guarantees the minimum level of quality we recommend, other cheaper varie-
ties generate more ash and smoke when burned.
• Always store pellets in a dry environment. Wood pellets easily absorb water if left in damp conditions. More
moisture in your pellets will produce smoke and the glass tube will need to be cleaned more often.
• Try to use some with a minimum of "bits". Small, fragmented pieces of pellets tend to create more ash and
clog the grate area more quickly.
• When you are ready to start, make sure you have the right tools, sufficient space and a clean, dry area for assembly.
• During assembly, children should be kept away from the product due to possible risk of injury.
• Ensure that this product is fully assembled as shown in the assembly manual before use.
• Check that all screws and bolts are tightened securely.
• Read the assembly instructions carefully and familiarise yourself with the procedure before assembling the unit.
• Check that you have all listed parts ready and familiarise yourself with each part before proceeding.
• Remove all components from the plastic bag and separate them into their groups.
• Make sure you have enough space to fit all the parts before assembly.
• Allow at least 2 metres clearance on each side and 2 metres at the top of the tube.
BEFORE USING
2 m
2 m 2 m
E NGL ISH 7